Line 441: |
Line 441: |
| | | |
| [[File:Certificate of SSDL membership Canada.jpg|thumb|Certificate of SSDL membership of CNSC Laboratory ]] | | [[File:Certificate of SSDL membership Canada.jpg|thumb|Certificate of SSDL membership of CNSC Laboratory ]] |
| + | |
| + | |
| + | |
| + | Detector Type Semi-conductor detector |
| + | Instrument Operating Range |
| + | |
| + | Operator Adjustable Controls |
| + | Turn On/Off |
| + | |
| + | To turn on the PAD, follow these steps: |
| + | 1. Press the front-panel button, hold for one second, and release it. The display should read “Change.” |
| + | |
| + | 2. Wait until the display reads “Enter.” |
| + | 3. Press the button again. |
| + | |
| + | 4. The display should now read “In.” The LED screen will flash briefly, and a single beep will be emitted from the unit. |
| + | |
| + | 5. If properly enabled, the unit will emit a single beep and the display will change to “d: 0.000 mSv.” It is now in Active Mode, and ready for use. |
| + | |
| + | To turn off the PAD, follow these steps: |
| + | 1. Press and hold the front-panel button for 8-10 seconds. The display should read “Change” at this point. |
| + | |
| + | 2. Continue to hold the front-panel button so that the words “Go Out” appear on the display. |
| + | |
| + | 3. Release the front-panel button at this time, and the display should read “: Out.” The unit will emit a single beep and the LED display will briefly flash. |
| + | |
| + | 4. If properly executed, the unit will emit a single beep and the display will return to “CNSC.” It is now in “Pause” mode. |
| + | |
| + | |
| + | Power Supply |
| + | 3 V Lithium coin Batteries |
| + | |
| + | |
| + | |
| + | Detector Type Semi-conductor detector |
| + | Instrument Operating Range |
| + | {| class="wikitable" |
| + | |'''Detector Type''' |
| + | |Semi-conductor detector |
| + | |- |
| + | |'''Instrument Operating Range''' |
| + | | |
| + | |} |