| Line 484: |
Line 484: |
| | | | | | |
| | |} | | |} |
| − | {| class="wikitable"
| |
| − | |'''Detector Type'''
| |
| − | |Semi-conductor detector
| |
| − | |-
| |
| − | |'''Instrument Operating Range'''
| |
| − | |
| |
| − | |-
| |
| − | |
| |
| | | | |
| − | '''Operator Adjustable Controls'''
| + | [[File:EPD pic 1.jpeg|thumb|Picture 1]] |
| − | |
| |
| − | | |
| − | '''Turn On/Off'''
| |
| − | | |
| − | | |
| − | To turn on the PAD, follow these steps:
| |
| − | {| class="wikitable"
| |
| − | |'''Press''' the front-panel button, '''hold''' for one second, and '''release''' it. The display should read “Change.”
| |
| − | |
| |
| − | |-
| |
| − | |'''Wait''' until the display reads “Enter.”
| |
| − | | |
| − | '''Press''' the button again.
| |
| − | |
| |
| − | |-
| |
| − | |The display should now read “In.” The LED screen will flash briefly, and a single beep will be emitted from the unit.
| |
| − | |
| |
| − | |-
| |
| − | |If properly enabled, the unit will emit a single beep and the display will change to “d: 0.000 mSv.” It is now in Active Mode, and ready for use.
| |
| − | |
| |
| − | |}
| |
| − | To turn off the PAD, follow these steps:
| |
| − | {| class="wikitable"
| |
| − | |'''Press''' and '''hold''' the front-panel button for 8-10 seconds. The display should read “Change” at this point.
| |
| − | |
| |
| − | |-
| |
| − | |'''Continue to hold''' the front-panel button so that the words “Go Out” appear on the display.
| |
| − | |
| |
| − | |-
| |
| − | |'''Release''' the front-panel button at this time, and the display should read “: Out.” The unit will emit a single beep and the LED display will briefly flash.
| |
| − | |
| |
| − | |-
| |
| − | |If properly executed, the unit will emit a single beep and the display will return to “CNSC.” It is now in “Pause” mode.
| |
| − | |
| |
| − | |}
| |
| − | |-
| |
| − | |
| |
| − | | |
| − | '''Power Supply'''
| |
| − | | | |
| − | | |
| − | | |
| − | 3 V Lithium coin Batteries
| |
| − | |} | |