Line 484: |
Line 484: |
| | | | | |
| |} | | |} |
| + | {| class="wikitable" |
| + | |'''Detector Type''' |
| + | |Semi-conductor detector |
| + | |- |
| + | |'''Instrument Operating Range''' |
| + | | |
| + | |- |
| + | | |
| | | |
| + | '''Operator Adjustable Controls''' |
| + | | |
| + | |
| + | '''Turn On/Off''' |
| + | |
| + | |
| + | To turn on the PAD, follow these steps: |
| + | {| class="wikitable" |
| + | |'''Press''' the front-panel button, '''hold''' for one second, and '''release''' it. The display should read “Change.” |
| + | | |
| + | |- |
| + | |'''Wait''' until the display reads “Enter.” |
| + | |
| + | '''Press''' the button again. |
| + | | |
| + | |- |
| + | |The display should now read “In.” The LED screen will flash briefly, and a single beep will be emitted from the unit. |
| + | | |
| + | |- |
| + | |If properly enabled, the unit will emit a single beep and the display will change to “d: 0.000 mSv.” It is now in Active Mode, and ready for use. |
| + | | |
| + | |} |
| + | To turn off the PAD, follow these steps: |
| + | {| class="wikitable" |
| + | |'''Press''' and '''hold''' the front-panel button for 8-10 seconds. The display should read “Change” at this point. |
| + | | |
| + | |- |
| + | |'''Continue to hold''' the front-panel button so that the words “Go Out” appear on the display. |
| + | | |
| + | |- |
| + | |'''Release''' the front-panel button at this time, and the display should read “: Out.” The unit will emit a single beep and the LED display will briefly flash. |
| + | | |
| + | |- |
| + | |If properly executed, the unit will emit a single beep and the display will return to “CNSC.” It is now in “Pause” mode. |
| + | | |
| + | |} |
| + | |- |
| + | | |
| + | |
| + | '''Power Supply''' |
| + | | |
| + | |
| + | |
| + | 3 V Lithium coin Batteries |
| + | |} |
| [[File:EPD pic 1.jpeg|thumb|Picture 1]] | | [[File:EPD pic 1.jpeg|thumb|Picture 1]] |